Framing Protruding Attic Wall

As you shim and plumb each section of wall drive 16d nails through the top plate into the framing with a hammer or nail gun.

Framing protruding attic wall.

In wood framing basics and wall plans that have openings with cripples above the header cut and nail together the king studs and trimmers first. If you see protruding drywall in a tall wall look to see if it s at the same height as the floor joists. Collar ties are horizontal members that like rafter ties extend from rafter to rafter but. In evaluating wall framing you ll be looking for walls that are out of plumb or not flat or straight.

Then position and nail them to the plates. Fasten the bottom plate by driving 16d nails through it into the floor. Allow for a top and. The plywood will create a smooth strong ceiling without having to apply drywall tape and mud to the ceiling.

Set the header on the trimmers and nail through the king studs to hold it in place. Score the shims with a utility knife and snap them off flush with the plate. Upper or lower walls may be out of plumb or the floor assembly may have components that are not flush. Run the plywood down to the top of the knee wall.

Two by four lumber is standard for framing most walls including short walls in the attic. Purchase enough to install a stud on each end of the wall and every 16 inches between. Nail the end studs to framing in the existing wall.